Reemo's 3D Printing Notes

I'm a software engineer who got into 3d printing in 2021 with an Anycubic i3 Mega S. Since then I've moved on to klipper on a Kingroon KP3S V3, a Sovol SV06 and a Siboor Voron V0.2 R1.

Consider any confidence I have regarding software justified, on the grounds that I'm terrified about software and been working with it too long.

Consider any confidence I have regarding hardware wildly exaggerated and a sign of hybris if any, on the grounds that I'm terrified about hardware and haven't had professional training in it.

Disclaimer (borrowed from GPL3)

THERE IS NO WARRANTY FOR THE PROGRAM, TO THE EXTENT PERMITTED BY APPLICABLE LAW. EXCEPT WHEN OTHERWISE STATED IN WRITING THE COPYRIGHT HOLDERS AND/OR OTHER PARTIES PROVIDE THE PROGRAM "AS IS" WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESSED OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. THE ENTIRE RISK AS TO THE QUALITY AND PERFORMANCE OF THE PROGRAM IS WITH YOU. SHOULD THE PROGRAM PROVE DEFECTIVE, YOU ASSUME THE COST OF ALL NECESSARY SERVICING, REPAIR OR CORRECTION.