Skip to content

Filament Loading Menu for Orbiter+DB8+Bambu Hotend

  • Adds Heat up and Cooldown Menu Entries
  • Extends the feed length to 80mm, roughly the length from reverse bowden to nozzle.
  • Decreases the Fast Load feed rate to 10mm/s (about ~25mm³/s) so the extruder doesn't skip.
[menu __main __filament __heat]
type: command
enable: {'extruder' in printer}
name: Heat to 245C
index: 0
gcode: M104 S245

[menu __main __filament __cooldown]
type: command
enable: {'extruder' in printer}
name: Cooldown
index: 1
gcode: M104 S0

[menu __main __filament __loadf]
type: command
name: Load Fil. fast
gcode:
    SAVE_GCODE_STATE NAME=__filament__load
    M83
    G1 E80 F600
    RESTORE_GCODE_STATE NAME=__filament__load

[menu __main __filament __loads]
type: command
name: Load Fil. slow
gcode:
    SAVE_GCODE_STATE NAME=__filament__load
    M83
    G1 E80 F240
    RESTORE_GCODE_STATE NAME=__filament__load

[menu __main __filament __unloadf]
type: command
name: Unload Fil.fast
gcode:
    SAVE_GCODE_STATE NAME=__filament__load
    M83
    G1 E-80 F960
    RESTORE_GCODE_STATE NAME=__filament__load

[menu __main __filament __unloads]
type: command
name: Unload Fil.slow
gcode:
    SAVE_GCODE_STATE NAME=__filament__load
    M83
    G1 E-80 F240
    RESTORE_GCODE_STATE NAME=__filament__load